|
|
All wood ballet barres
are shipped in individual cardboard tubes and are hand-sanded
without a liquid finish. All ballet barres are made of 1-3/4" diameter Poplar wood. For an additional cost, Maple and Oak are also available with the same diameter.
These
Fixed Height Ballet Barre Brackets are very sturdy and weigh
1 lb. each. They have a bright chrome finish. They come
with #12 x 2" flat head screws. |
SPACING
FOR BRACKETS |
| 4'
Barre |
2
brackets spaced 32" apart (8" overhang) |
| 6'
Barre |
2
brackets spaced 48" apart (12" overhang) |
| 8'
Barre |
2
brackets spaced 64" apart (16" overhang) |
| 10'
Barre |
2
brackets spaced 80" apart (20" overhang) |
| 14'
Barre |
3
brackets, 1 centered with 64" space
on each side
(20" overhang) |
| 16'
Barre: |
3
brackets, 1 centered with 80" space
on each side
(16" overhang) |
|
| There
is a 80" maximum span between brackets on 1-3/4" diameter barres. |
| Minimum
overhang is 2". Maximum overhang is 20". |
| |
SUGGESTED
BARRE HEIGHTS FOR FIXED BRACKETS |
| Single
Barre: |
32"
- 46" from floor (waist level) |
| Double Barre: |
32"
- 34" lower barre |
| |
44"
- 46" from the floor for upper barre |
|
| Distance
from wall to barre: |
INSIDE
= 7 1/4" (approx.) |
| |
OUTSIDE = 9"
(approx.) |
| |
All
dimensions are approximate and may change without notice. |
| |
|
WARP TOLERANCE FOR WOOD IS 3/16" PER 4' SECTION
|
| |
|
1. Sight down barre to determine apex of warp.
2. Center the level on apex and place 3/16" drill bit in gap.
3. If drill bit slides freely and completely through gap, the barre is beyond our warp tolerance. |
| |
Your Cart Is Empty
