Adjustable Ballet Bar Specifications

Ballet Bar Styles with Adjustable Brackets

Ballet Bar - Adjustable Wall-Mount, Single Barre, 4'-8' or Custom Length
Ballet Bar - Adjustable Wall-Mount, Single Barre, 10'-16' or Custom Length
Ballet Bar - Adjustable Wall-Mount, Double Barres, 4'-8' or Custom Length
Ballet Bar - Adjustable Wall-Mount, Double Barres, 10'-16' or Custom Length
Portable Ballet Bar, Single Barre, 4'-8'
Portable Ballet Bar, Single Barre, 10'-16'
Portable Ballet Bar, Double Barres, 4'-8'
Portable Ballet Bar, Double Barres, 10'-16'
All Dance Equipment and Supplies

All wood ballet bars are shipped in individual cardboard tubes and are hand-sanded without a liquid finish. All ballet bars are made of 1-3/4" diameter Poplar wood. For an additional cost, Maple, Oak and other woods are also available in 1-3/4" diameter.

These Adjustable Ballet Barre Brackets are very sturdy and weigh 2 1/2 lb. each. (Double adjustable weigh 3 1/2 lb.) They have a bright chrome finish. They come with #12 x 2" flat head screws. Wall channel allows approximately 14" of adjustment.

SPACING FOR BRACKETS
4' Barre	2 brackets spaced 32" apart (8" overhang)
6' Barre	2 brackets spaced 48" apart (12" overhang)
8' Barre	2 brackets spaced 64" apart (16" overhang)
10' Barre	2 brackets spaced 80" apart (20" overhang)
14' Barre	3 brackets, 1 centered with 64" space on each side (20" overhang)
16' Barre:	3 brackets, 1 centered with 80" space on each side (16" overhang)

There is a 80" maximum span between brackets on 1-3/4" diameter barres.

Minimum overhang is 2". Maximum overhang is 20".

No more than three adjustable brackets per barre length.

It is harder to adjust barres that have more than three brackets.

SUGGESTED HEIGHTS FOR ADJUSTABLE BRACKETS

Bottom of channel at 29" from the floor.

Barre height adjustable from 30" - 44" (approx.)

Distance from wall to barre:

INSIDE = 7 1/4" (approx.)

OUTSIDE = 9" (approx.)

All dimensions are approximate and may change without notice.

WARP TOLERANCE FOR WOOD IS 3/16" PER 4' SECTION

Fixed Bracket Ballet Barre

1. Sight down barre to determine apex of warp.
2. Center the level on apex and place 3/16" drill bit in gap.
3. If drill bit slides freely and completely through gap, the barre is beyond our warp tolerance.